Honeywell International Inc. 8DL5870API Manuale Utente
- 3 -
5870API-005-V0
INSERT TIP OF
SCREWDRIVER.
PUSH IN TO
RELEASE CLIP
Figure 2 – Replacing the 5870API Battery
3. Check the battery polarity orientation before
installing (see Figure 3).
4. Insert the battery securely in the sensor.
5. Snap the sensor cover back in place.
5870API-001-V0
CR2
Figure 3 – Replacing the 5870API Battery
Table 1: 5870API Operating Mode Choices
SPECIFICATIONS
Dimensions:
1.8" H x 1.7" W x 0.63" D
1.8" H x 1.7" W x 0.63" D
(45.72 mm x 43.18 mm x 16.02 mm)
Power:
Single 3V Ademco 469, Panasonic CR2, Sanyo CR2,
or Duracell DLCR2 Lithium Battery
Single 3V Ademco 469, Panasonic CR2, Sanyo CR2,
or Duracell DLCR2 Lithium Battery
Environmental Conditions:
14
° to 122°F (-10° to 50°C)
<90% RH (non-condensing)
5870API-003-V1
5870API
(Rear View)
REPLACE ADHESIVE WHEN RELOCATING THIS DEVICE
1.8"
1.7"
TAMPER
Operating Mode
Loop
Faults when…
Restores when…
Short Travel Time
Detection
Detection
1
Asset/sensor is moved for 1 (+1, -0)
second.
second.
Motion of the asset/sensor has stopped for 3
(+1, -0) seconds.
(+1, -0) seconds.
Long Travel Time
Detection
Detection
2
Asset/sensor is moved for 5 (+1, -0)
seconds
seconds
Motion of the asset/sensor has stopped for 3
(+1, -0) seconds.
(+1, -0) seconds.
Open/Close Sensor
3
Asset/sensor is tilted >30 (+/-10)
degrees (with respect to the horizon)
degrees (with respect to the horizon)
Asset/sensor is tilted <15 (+/-5) degrees
(with respect to the horizon).
(with respect to the horizon).
FCC & IC ID No's