Honeywell International Inc. 8DLLYNXREN-5 Manuale Utente
–49–
System Operation
To define AUX function:
---------------
+
FUNCTION
+
AUX
+
action separated by +
AUX
terminated by +
AUX
+
AUX
To send message to pager:
Press and hold
AUX
key 2 seconds (4 beeps)
To program Follow Me Announcement telephone number
:
+
FUNCTION
+ [65]
Speaker Phone Operation
To place a call or answer a call using the speaker phone:
To place a call or answer a call using the speaker phone:
[#] +
AUX
To flash (switch between two calls using call waiting):
AUX
To hang up and exit speaker phone mode:
OFF
To enable/disable (toggle) ringer:
[#] +
VOLUME
+
AUX
To return the keypad to telephone mode after disarming the system:
[#] +
AUX
Remote Phone Control Feature
The remote phone control feature, which must be enabled in field
✻
91, allows the user to access the security
system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring
count specified in field
count specified in field
✻
95, and will announce “SYSTEM ENTER CODE” every three (3) seconds for the
next eight (8) seconds. During this period the panel will wait for a valid User Code to be entered. If a valid
User Code is not entered or the eight (8) second period expires a modem tone will be generated for remote
programming (Compass Downloading). If a valid User Code has been entered, the control will announce the
current system status and/or beeping sounds.
User Code is not entered or the eight (8) second period expires a modem tone will be generated for remote
programming (Compass Downloading). If a valid User Code has been entered, the control will announce the
current system status and/or beeping sounds.
Keypad Functions
Remote Phone Control Feature
To remotely disarm system:----
To remotely disarm system:----
+ [1]
To remotely arm in AWAY mode:
+ [2]
To remotely arm in STAY mode:
+ [3]
To remotely arm in AWAY or STAY with no delay:
+ [2] or [3] + [0]
To remotely activate X-10 devices 1-6:
[#] + [4] + device no.
To remotely activate X-10 devices 7 & 8:
+ [#] + [4] + device no.
To remotely deactivate X-10 devices 1-6:
[#] + [7] + device no.
To remotely deactivate X-10 devices 7 & 8:
+ [#] + [7] + device no.
To remotely Bypass zones: -----
+ [6] + zone no.
To remotely activate Forced Bypass:
+ [6] + [#]
To remotely check system status:
[
✻
]
To end remote phone control session: Hang Up or enter
+ [9]
Quick Arm Note
The installer code and
babysitter code cannot
disarm the system if
armed by Quick Arm
method.
NOTE
The ARMED and READY LEDs blink alternately
when the Speaker Phone is active.
when the Speaker Phone is active.