ademco 8DLPHS8-US Manuale Utente
HONYEYWELL
PRELIMINARY
3G Communicator
Lyric-3G / Lyric-3GC
Installation Instructions
General Information
The Lyric-3G/Lyric-3GC Communication Modules allow the Lyric Controller to communicate with the Central Station via
the 3G cellular network.
IMPORTANT: Before installing the communication module, make sure power (both AC and battery) is removed from the
IMPORTANT: Before installing the communication module, make sure power (both AC and battery) is removed from the
controller or use the “Install Cellular Module” mode described in the Replacing the Module section below.
Installing the Lyric-3G Module
1. Install the provided FCC/IC label (P/N 800-19687) on
the control’s case back.
2. Remove bezel from right-hand side of control to expose
the radio module slot. To remove the bezel, push
upward then slide it out.
3. Insert the module into the slot. Push firmly to mate the
edge connector. Install the securing screw to ensure
proper connection and operation.
4. Replace the bezel.
5. After all other controller connections are made, power
up the controller.
6. Program and register the module during the controller’s
initial association with its AlarmNet 360 account. Refer
to the controller’s Programming Guide for details.
7. Check the signal strength before permanently locating
the Lyric Controller. See Checking Signal Strength
section.
Typical FCC/IC Label Location
Removing the Bezel
Installing the Lyric-3G Module
Replacing the Module
In the event the module needs to be replaced, the Control must first be put in module replacement (“Install Cellular
Module”) mode to avoid causing a tamper alarm or damaging the module. Module replacement mode deactivates
tamper protection and removes power from the module connector for about 15 minutes.
1. Select the Install Cell button.
User: Security –Tools – user code – Advanced – Install
Cellular Module
Installer: Security –Tools – installer code – Test –
Install Cellular Module
a. Select Yes at the prompt to continue.
b. A popup window displays steps for module
replacement. Keep this window open until
replacement is completed
2. Remove the side bezel. See diagram at right.
3. Remove the screw that secures the module.
4. Remove the communication module from its
connection slot by using the pull tab.
5. Insert the new module into the slot. Push firmly to
mate the edge connector. Replace the screw.
6. Replace the bezel.
7. When installation is complete, press OK at the
replacement steps window. Confirmation of proper
installation appears. Press OK to exit.
SEE BOTTOM OF PAGE 2
FOR AGENCY
STATEMENTS
FOR AGENCY
STATEMENTS