Chiayo Electronics Co Ltd DB-2400 Manuale Utente
2
Instructions
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
0.5
centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least
0.5 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Frequency: 2400~2483.5MHz
Maximal power: 6.47dBm
CE declaration info: www.chiayo.com.tw/declaration.html
Battery installation & indicator
When the transmitter is switched
ON, the battery power LED (red)
will blink once to denote the
batteries installed are in good
condition
ON, the battery power LED (red)
will blink once to denote the
batteries installed are in good
condition
If the LED remains illuminated the
batteries have expired and require
replacement.
batteries have expired and require
replacement.
This transmitter requires 2 x AA
batteries to operate.
batteries to operate.
To install, open the battery cover
using the cover release buttons
and insert the batteries into the
battery compartment.
using the cover release buttons
and insert the batteries into the
battery compartment.
IMPORTANT: Batteries contain a corrosive acid that may leak and
damage the transmitter when stored for a long period. Batteries should be
removed from the transmitter before storing without use for more than 4
weeks.
damage the transmitter when stored for a long period. Batteries should be
removed from the transmitter before storing without use for more than 4
weeks.