Toshiba Client Solutions CO. LTD. UPSU7FPC2 Manuale Utente
USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
Refer to the FCC information section for the detailed information.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.The available scientific evidence does not
show that any health problems are associated with using low power
wireless devices. There is no proof, however, that these low power wireless
devices are absolutely safe. Low power Wireless devices emit low levels of
radio frequency energy (RF) in the microwave range while being used.
Whereas high levels of RF can produce health effects (by heating tissue),
exposure of low-level RF that does not produce heating effects causes no
known adverse health effects. Many studies of low-level RF exposures
have not found any biological effects. Some studies have suggested that
some biological effects might occur, but such findings have not been
confirmed by additional research. This Product has been tested and found
to comply with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65.
If 5GHz band is supoorted on the PC, refer to:
Compliance with FCC requirement 15.407(c) Data transmission is always
initiated by software, which is the passed down through the MAC, through
the digital and analog baseband, and finally to the RF chip. Several special
packets are initiated by the MAC. These are the only ways the digital
baseband portion will turn on the RF transmitter, which it then turns off at
the end of the packet. Therefore, the transmitter will be on only while one of
the aforementioned packets is being transmitted. In other words, this
device automatically discontinue transmission in case of either absence of
information to transmit or operational failure.
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
Refer to the FCC information section for the detailed information.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.The available scientific evidence does not
show that any health problems are associated with using low power
wireless devices. There is no proof, however, that these low power wireless
devices are absolutely safe. Low power Wireless devices emit low levels of
radio frequency energy (RF) in the microwave range while being used.
Whereas high levels of RF can produce health effects (by heating tissue),
exposure of low-level RF that does not produce heating effects causes no
known adverse health effects. Many studies of low-level RF exposures
have not found any biological effects. Some studies have suggested that
some biological effects might occur, but such findings have not been
confirmed by additional research. This Product has been tested and found
to comply with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65.
If 5GHz band is supoorted on the PC, refer to:
Compliance with FCC requirement 15.407(c) Data transmission is always
initiated by software, which is the passed down through the MAC, through
the digital and analog baseband, and finally to the RF chip. Several special
packets are initiated by the MAC. These are the only ways the digital
baseband portion will turn on the RF transmitter, which it then turns off at
the end of the packet. Therefore, the transmitter will be on only while one of
the aforementioned packets is being transmitted. In other words, this
device automatically discontinue transmission in case of either absence of
information to transmit or operational failure.
Legal Footnotes
Non-applicable Icons
Certain computer chassis are designed to accommodate all possible
configurations for an entire product series. Therefore, please be aware that
your selected model may not have all the features and specifications
corresponding to all of the icons or switches shown on the computer
chassis.
configurations for an entire product series. Therefore, please be aware that
your selected model may not have all the features and specifications
corresponding to all of the icons or switches shown on the computer
chassis.
CPU
Central Processing Unit (CPU) Performance Legal Footnotes.
CPU performance in your computer product may vary from specifications
under the following conditions:
CPU performance in your computer product may vary from specifications
under the following conditions:
User's Manual
7-7