Universal Global Scientific Industrial Co. Ltd. VZ22Q Manuale Utente
VZ22Q LTE Module
V0.1
USI
Confidential
Page 19 of 23
i.
To avoid a cross-talk issue result from having no enough space between channels or
input/output traces. The cross-talk may interfere in analog signal, especially the
input/output traces. The cross-talk may interfere in analog signal, especially the
MIC1P/MIC1N and MIC2P/MIC2N. In Figure 5-4, the isolation between
LINE_IN_R/LINE_IN_L, and MIC1P/MIC1N are routing as wider as possible (L at least
60 mils).
60 mils).
Figure 5-4. The routing for Analog Inputs (L>60 mils, D≦10 mils)
ii.
The MIC1P/MIC1N and MIC2P/MIC2N input signals are more sensitive than the other
signals. These two signals may route to the other layer if possible, and we can see that in
Figure 5-5 .In Figure 5-5, LINE_IN_R/LINE_IN_L those input signals is routing on Layer-1.
But MIC1P/MIC1N and MIC2P/MIC2N input are routing on different Layer (Ex. Layer-2)
between codec and phone jack input.
signals. These two signals may route to the other layer if possible, and we can see that in
Figure 5-5 .In Figure 5-5, LINE_IN_R/LINE_IN_L those input signals is routing on Layer-1.
But MIC1P/MIC1N and MIC2P/MIC2N input are routing on different Layer (Ex. Layer-2)
between codec and phone jack input.
Figure 5-5. The special routing for MIC input signal (D≦10 mils)
iii.
For better performance, analog input & output traces width should be as wide as possible.
MIC1P/MIC1N, MIC2P/MIC2N >10 mils (15mils is better.)
MIC1P/MIC1N, MIC2P/MIC2N >10 mils (15mils is better.)