Lectrosonics Inc SMWBB2 Manuale Utente

Digital Hybrid Wireless Belt-Pack Transmitters

Rio Rancho, NM

Transmitter Operating

Instructions

• Install battery(s)
• Set the configuration to the Xmit mode (see previ-

ous section)

• Turn power on in the Standby mode (see previous

section)

• Connect microphone and place it in the position

where it will be used.

• Have user talk or sing at the same level that will be

used in the production, and adjust the input gain so

that the

-20 LED blinks red on louder peaks.

Gain

Freq
Rolloff
Compat

-40

-20

Gain

Use the UP and DOWN

arrow buttons to adjust

the gain until the -20

LED blinks red on

louder peaks

Signal Level

-20 LED

-10 LED

Less than -20 dB

Off

-20 dB to -10 dB

Green

Off

-10 dB to +0 dB

Green

+0 dB to +10 dB

Red

Green

Greater than +10 dB

Red

• Set the frequency and compatibility mode to match

the receiver.

• Turn the RF output on with the

Rf On? item in the

power menu, or by turning the power off and then

back on while holding the power button in and wait-

ing for the counter to reach 3.

NOTE: The translucent “bubble” next to the

antenna connector is an IR port that can be

used to transfer settings from an IR enabled

Lectrosonics receiver. Refer to the receiver manual

for details.

Record Mode Operating

Instructions

• Install battery(s)
• Set the configuration to the Record mode (see pre-

vious section)

•  Insert microSDHC memory card
•  Turn power on
•  Format memory card
•  Connect microphone and place it in the position

where it will be used.

• Have user talk or sing at the same level that will be

used in the production, and adjust the input gain so

that the

-20 LED blinks red on louder peaks

Gain

Rolloff
Naming
SD Info

-40

-20

Gain

Use the UP and DOWN

arrow buttons to adjust

the gain until the -20

LED blinks red on

louder peaks

Signal Level

-20 LED

-10 LED

Less than -20 dB

Off

-20 dB to -10 dB

Green

Off

-10 dB to +0 dB

Green

+0 dB to +10 dB

Red

Green

Greater than +10 dB

Red

• To start recording, press the record button (UP ar-

row button)

• To stop recording, press and hold the record (UP

arrow button) until the word SAVED appears on the

screen

-40

-20

REC

MENU/SEL and UP

arrow buttons are

labeled by the on

screen icons

UP arrow button is

record start/stop

MENU/SEL opens

the menu

To play back the recordings, remove the memory card

and copy the files onto a computer with video or audio

editing software installed.