optex TR-10U Manuale Utente

1

2

1

3

1

2

1

3

1

2

1

3

1

2

1

3

1

2

1

3

TR-10U REPEATER

This product is only compatible with the Wireless 1000 series.

This product is not supposed to use outside of the building.

Do not expose the TR-10U to high temperature changes, rapid changes in temperature, 

steam, high humidity or oily smoke.

• A steel door, reinforced concrete, or other metal obstructions between the transmitter and 

TR-10U and the receiver.

• Installing either the transmitter or TR-10U or the receiver on a metal surface.

• Places near strong radio sources, such as broadcast stations or high power lines.

• To comply with the FCC RF exposure compliance requirements, this device and its antenna 

must not be co-located or operating in conjunction with any other antenna or transmitter.

Use the TR-10U at least 3ft (1m) away from following devices: TV, radio, personal 

computer, microwave oven, refrigerator, and any device that has an electric motor 
(This may cause malfunction).

Do not drop or impact the TR-10U in any manner.

Do not change or modify the products without approval from a professional engineer 

or electrician. Manufacturer can not accept responsibility for any accidents.

Harsh cleaners such as paint removers or benzene may ruin the surface. Use a soft, 

wet cloth and mild soap or detergent to clean.

Do not use any other AC adaptor except including one. 

Use the mounting screw on 
a wall. Leave some length 
of the screw out for the 
mounting hole of the TR-
10U.

Pull out the stand on the 
back of the TR-10U and 
place it on any flat surface.

FRONT

Power 

indicator

Channel indicator 1

Channel indicator 2

Channel indicator 3

Switch 1

Power 

switch
Switch 2

Adaptor 

jack

BACK

Mounting 

hole

Stand

Switch 1 Activating “LEARN MODE” 

and “TEACH MODE”

Switch 2 Activating making selection

AC Adaptor

Mounting screw

Each transmitter has a unique transmission code, which can be automatically “LEARN” by the TR-10U. 
The TR-10U’s channel must be taught to respond to the appropriate transmitter.
The channel characteristics can be programmed as shown below.

A) The TR-10U automatically 

starts in “LEARN MODE” 
if no transmitter code has 
been programmed.

OR

B) Press and hold Switch 1 

until the power indicator 
starts to flash.

Activate the transmitter you wish to teach the TR-10U.

The corresponding channel indicator flashes rapidly at intervals of 

1 sec according to the N number of transmitters, N=Maximum 4.

TR-10U starts 

in Channel 1.

Press Switch 2 to advance to the next 

channel.

Press Switch 2 to revert to 

normal operation status.

Revert to normal operation status before use.

Verify that each transmitter has been learned by the TR-10U by triggering them.

Turning off the devices, or losing power will not affect the transmitter or the TR-10U’s code memory.

1) Hold Switch 1 until the power indicator starts to flash.

2) Press Switch 2 until the appropriate channel indicator is lit.

3) Press Switch 1 to erase. Channel indicator will start to flash.

4) Press Switch 2 a few times until the power indicator stops flashing and remains lit.

Note: To erase all programming and revert to the factory default setting, turn on the 

power while pressing and holding Switch 1.

RECEPTION (TRANSMITTER TO TR-10U)
  1000 ft. (300 m)  (with TD-10U, open field, line of sight)
  700 ft.   (210 m)  (with TS-10U/TC-10U, open field, line of sight)
TRANSMISSION (TR-10U TO RECEIVER)
  1000 ft. (300 m)  (with RC-10U/RG-10U, open field, line of sight)

Measurements were made over and level unobstructed ground. Natural or man-made 
obstacles and other environmental factors can interfere with or otherwise reduce the 
transmission range. Always confirm the actual transmission range during the system 
installation. Please also use the information below as a reference for the transmission 
performance.

Plaster construction:

Reinforced concrete construction:

Use only the power adaptor supplied with the product.

150 ft. (45m)
100 ft. (30m)

110 ft. (33m)

70 ft. (21m)

150 ft. (45m)
100 ft. (30m)

* When you will waste product, please disassemble the product and waste according to states law.