Intermatic H0006 Manuale Utente
-------------------------------------- DRAFT COPY --------------------------------------
Instructions for Model HA06 – In-wall Dimmable Switch – using the HA07
Controller
<Front cover>
User’s Manual
*Illustration of HA06 In-wall Dimmable Switch*
<Inside cover>
General Description
Instructions for Model HA06 – In-wall Dimmable Switch – using the HA07
Controller
<Front cover>
User’s Manual
*Illustration of HA06 In-wall Dimmable Switch*
<Inside cover>
General Description
Federal Communications Commission Statement
This device complies with part 15 of the FCC rules. Operation of this device is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation.
This device complies with part 15 of the FCC rules. Operation of this device is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna or device.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna or device.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
WARNING!
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment
.
Enclosed you will find:
1 Indoor In-wall Dimmer (for use with HA07, HA09, or any Z-wave enabled remote
controller)
1 Indoor In-wall Dimmer (for use with HA07, HA09, or any Z-wave enabled remote
controller)
Installation Instructions
In-wall Dimmer Switch:
In-wall Dimmer Switch:
1. Hard-wire the In-wall switch to a 125VAC supply using the black wire lead.
2. Hard-wire the In-wall switch to a load you wish to control using the blue wire
2. Hard-wire the In-wall switch to a load you wish to control using the blue wire
lead. Maximum rating of the load branch should not exceed 300 Watts.
Remote Controller