Computime Limited CT-EM2603 Manuale Utente
10 GND
Ground
Ground supply
11 ANT
ANT
receiver input/transmitter output
12 GND
Ground
Ground supply
13 nRESET
I
Active low chip reset (internal pull-up)
14 NC
15 NC
Pin#
Signal
Direction
Description
16
VBRD
Power
Pads supply (2.1-3.6V)
17
NC
18
NC
19
MOSI
I
SPI Data, Master Out / Slave In (from Host to EM260
20
MISO
O
SPI Data, Master In / Slave Out (from EM260 to Host)
21
SCLK
I
SPI Clock (from Host to EM260)
22
NSSEL
I
SPI Slave Select (from Host to EM260)
23
PTIEN
O
Frame signal of Packet Trace Interface (PTI)
24
PTIDATA
O
Data signal of Packet Trace Interface (PTI)
25
NHOSTINT
O
Host Interrupt signal (from EM260 to Host)
26
NC
27
NC
28
NC
29
NC
30
SIFCLK
I
Serial interface, clock (internal pull-down)
11.0 Block Diagram
Figure 4: Block Diagram
12.0 Circuit Description
The module contains an IEEE 802.15.4 compliant RF transceiver, high speed oscillator, RC
oscillator. The module is intended to running the Ember ZigBee software or other ZigBee
network implementation, depending on the specific version.
The application software together with the ZigBee protocol software stack can be programmed
in Flash memory through SIF module, using an evaluation board from Ember InSight Desktop.
To support user-defined applications, the module exposes the Ember Serial API over the SPI,
which allows application development to occur on a Host microcontroller of choice. In addition
to the four SPI signals, two additional signals, nHOST_INT and nWAKE, provide an easy-to-use
handshake mechanism between the Host and the module. Also, an integrated voltage regulator,
power-on-reset circuitry, sleep timer, and low-power sleep modes are available. The deep sleep
oscillator. The module is intended to running the Ember ZigBee software or other ZigBee
network implementation, depending on the specific version.
The application software together with the ZigBee protocol software stack can be programmed
in Flash memory through SIF module, using an evaluation board from Ember InSight Desktop.
To support user-defined applications, the module exposes the Ember Serial API over the SPI,
which allows application development to occur on a Host microcontroller of choice. In addition
to the four SPI signals, two additional signals, nHOST_INT and nWAKE, provide an easy-to-use
handshake mechanism between the Host and the module. Also, an integrated voltage regulator,
power-on-reset circuitry, sleep timer, and low-power sleep modes are available. The deep sleep