Sennheiser Electronic Corp RR5000 Manuale Utente
EN Using additional functions
24 |
RS 5000
Using additional functions
The following additional functions are not required for normal
use of the wireless headphone system. You can, however,
extend the potential use of the system and adjust some of
the functions to your individual needs.
use of the wireless headphone system. You can, however,
extend the potential use of the system and adjust some of
the functions to your individual needs.
Pairing one or several stethoset receivers with
the transmitter
the transmitter
The stethoset receiver and the transmitter of your wireless
headphone system are factory pre-paired. The following
steps are only necessary if you want to pair additional ste-
thoset receivers with the transmitter.
headphone system are factory pre-paired. The following
steps are only necessary if you want to pair additional ste-
thoset receivers with the transmitter.
You can simultaneously use up to 4 paired stethoset receivers
with your transmitter. All other paired and switched-on
receivers cannot connect to the transmitter.
with your transmitter. All other paired and switched-on
receivers cannot connect to the transmitter.
왘
Place the stethoset receiver into the transmitter’s charging
compartment.
The stethoset receiver is paired with the transmitter.
compartment.
The stethoset receiver is paired with the transmitter.
Advanced settings
The advanced settings allow you to adjust the wireless head-
phone system to your individual needs and to protect the set-
tings against accidental changes.
phone system to your individual needs and to protect the set-
tings against accidental changes.
Activating the protected settings mode
You can change the advanced settings by activating the pro-
tected settings mode:
tected settings mode:
If more than one stethoset receiver is connected to the
transmitter, the remaining operating time/charge
status and the hearing profile cannot be displayed. In
addition, the balance and a hearing profile cannot be
adjusted. These functions can only be used/adjusted
when only one stethoset receiver is connected to the
transmitter.
transmitter, the remaining operating time/charge
status and the hearing profile cannot be displayed. In
addition, the balance and a hearing profile cannot be
adjusted. These functions can only be used/adjusted
when only one stethoset receiver is connected to the
transmitter.
+
RS_5000_570727_0117_PRT.book Seite 24 Montag, 10. Oktober 2016 2:52 14