Checkpoint Systems Inc. FISOLRR Manuale Utente

I L S   O p e n   P l u s   E x i t   A n t e n n a   I n s t a l l a t i o n :   A p p e n d i x  

1-27

** Qty. 2 ID ISC.ANT1400/760 antennas, antenna spacing (antenna center), same flow 
direction, Tag 46 mm x 75 mm (1.8” x 3”), sensitivity / minimum field strength Hmin=80 
mA/m rms, transmitting power 8 W, tag orientation parallel to antenna for horizontal 
movement through the antenna.

*** Tag 46 mm x 75 mm (1.8” x 3”), sensitivity / minimum field strength Hmin=80 mA/
m rms, transmitting power 8 W, aligned in all 3 dimensions for horizontal movement 
through the antenna.

**** Electrical data refer only to the antenna with tuning circuit.

The following section can be used for troubleshooting to ensure the correct parameters are 
set.

Verify the following settings are configured for the operating power, transponder and ISO 
Host Mode:

Connect a laptop to the reader on the gate:

Disconnect RJ45 cable between the reader and serial-to-ethernet board at the serial 
port. 

Plug the Checkpoint RJ45-to-DB9 cable adapter into the serial-to-ethernet board.

Connect a serial cable from the RJ45-to-DB9 cable adapter to the laptop’s serial 
port.

Launch ISOStart Software.

Click Configuration.

Permissible overall transmitting power per 
antenna gate

• EU-territory (per EN 300 330)

• USA (per. FCC Part 15)

10.0 W

8.0 W

• Operating frequency

13.56 MHz

Ranges / pass-through width in gate Type -B 
and -C

• One tag orientation

• All tag orientations

approx. 115 cm** (45”)

approx.   95 cm*** (37”)

Antenna connection

1 x SMA plug (50 

Ω)

Antennac connector cable

RG58, 50 

Ω

, approx. 2 m long (6.6 ft)

Electrical Data****