Wyse Technology WT3320 Manuale Utente

Installation Procedures

The plastic shroud may be installed to conceal the cable connectors at the rear of 
the terminal housing. A retaining loop is included to keep the cables together. 
Proceed as follows.

1. Attach the upper and lower shroud mounting clips as shown in figure 6-5, using 

the existing screws.

2. Attach the cables to their respective connectors on the back panel of the 

terminal (see “Connecting the Terminal”).

3. Gather the cables together and place the retaining loop over them. Insert the 

ends of the retaining loop into the catches on the lower shroud mounting clip 
(see the following figure).

4. Gently pull the lower ends of the shroud apart and place it over the cables.

5. Place the slots in the lower end (split end) of the shroud under the lower shroud 

mounting clip, as shown in the following figure.

6. Rotate the upper end of the shroud until the top slot goes over and engages the 

upper mounting clip, as shown in the following figure.

Retainer Catches

Cable Retaining

Loop