Pioneer Corporation K041 Manuale Utente

6.2.User’s Manual Requirement of FCC/IC rules

FCC/IC User's manual requirements that are required by FCC/IC rules are described on user's manual

of the vehicle as followings;

『" NXH-9718

" and “NXH-9918” and “DVZ-0118” is installed in motor vehicle,

" NXH-9718

" and “NXH-9918” and “DVZ-0118” has no manual for user.

So, following FCC/IC user’s manual statement will be stated in user’s manual of the motor vehicle.』

FCC Regulations

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation of the device

OET

OET

OET----65

65 CAUTION:

CAUTION:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to
OET65. This equipment has very low levels of RF energy that it deemed to comply without maximum
permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated
keeping the radiator at least 20cm or more away from person’s body (excluding extremities: hands,
wrists, feet and ankles).

Co-location : This transmitter must not be co-located or operated in conjunction with any other antenna

or transmitter.

Information to User

Alteration or modifications carried out without appropriate authorization may invalidate the user's

right to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on A circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.