Kenwood USA Corporation 33293110 Manuale Utente
11
SCANNING THE CHANNELS
You can scan all 8 channels of the transceiver to search for a
signal. When the transceiver verifies a signal on a channel, it
proceeds to check whether or not its QT/ DQT setting
matches that which is set up on your transceiver. If the QT/
DQT matches, the transceiver stops at the channel and opens
the squelch so you can listen to the call. If the QT/ DQT does
not match, the call is ignored and scanning continues.
signal. When the transceiver verifies a signal on a channel, it
proceeds to check whether or not its QT/ DQT setting
matches that which is set up on your transceiver. If the QT/
DQT matches, the transceiver stops at the channel and opens
the squelch so you can listen to the call. If the QT/ DQT does
not match, the call is ignored and scanning continues.
To begin scanning:
1
Press and hold the
▲
key for 3 seconds.
•
SCAn appears on the display.
2
When a signal is detected and the QT/ DQT matches, the
channel number appears on the display and blinks.
channel number appears on the display and blinks.
•
If you prefer to stop the scan at a particular channel, simply
press the
press the
▲
or
▼
key.
3
When the signal is no longer present, the transceiver waits
for 5 seconds before scanning continues.
for 5 seconds before scanning continues.
•
If a new signal appears before the 5 seconds elapse, the
transceiver will remain on the channel until the signal is no
longer present again, at which time it will again wait for
3 seconds before continuing.
transceiver will remain on the channel until the signal is no
longer present again, at which time it will again wait for
3 seconds before continuing.
4
To end the scan at any time, press the MENU key or the
CAL key.
CAL key.
•
The transceiver returns to the channel you were using before
you started scanning.
you started scanning.