Uniden America Corporation UU033R Manuale Utente

Thank you for purchasing Uniden’s BC906W wireless microphone. Now you can be up 

to 100 meters away from your CB and still remain connected.   Enjoy mobility while still 

being connected to your Uniden Bearcat CB.
At Uniden, we’ll take care of you!  If you need any assistance with this product, please 

call our Customer Care Line at:  800-297-1023 or 817-858-2929

The BC906W is NOT waterproof or water-resistant. Keep it away from water and do not 

let it get submerged in water. If the mic gets wet, power it off and dry off the casing. 
Keep out of prolonged exposure to direct sunlight. Prolonged exposure could heat the 

internal workings of the mic past safe levels.

 x BC906W Microphone

 x BC906W Cradle with mounting screws

 x DC Charger (Car charger plug with mini-USB connection)

 x Ni-MH battery (BT-1008)

 x Belt Clip

Microphone
LED

button

Speaker

button

button

button

Mini-USB Charging Port

Green

Solid On

Linked, battery charged

Red

Solid On

Linked, low battery

All

Off

Powered down

Green

Long Flash

Transmitting, battery charged

LED

FIND/SYNC

Button

Red

Long Flash

Transmitting, low battery

Green

Short Stutter

Registration mode, battery charged

Red

Short Stutter

Registration mode, low battery

Orange/Green Short Flash

Not linked, battery charged

Orange/Red

Short Flash

Not linked, low battery

Green/Red

Long Flash

Charging, battery not full

All

Long Flash

Unregistered

To...

Do this...

Install 

batteries in 

mic

1.  Remove the back battery cover.
2.  Insert the Ni-MH battery, connecting it to the mic at the plug.
3.  Replace the back cover.
4.  Use the DC charger to charge battery completely before using.

Mount the  

microphone 

cradle

1.  Mount the cradle using the supplied screws.
2.  Disconnect the current wired mic
3.  Connect the microphone cradle.
4.  Turn on CB. The cradle LED flashes red while it powers up, then 

becomes solid red.

Sync the mic

On the mic, press PTT or SYNC/Power On/Off. The mic turns on and the 

LED turns green when it has synced with the CB.
If you press PTT to turn on the mic, an error tone sounds. It will stop when 

you release PTT after the mic is powered up. 
If you are out of range and move back in range, the mic will 

automatically re-sync.

Install the belt 

clip (if using)

If you are using the belt clip, slide it onto the belt clip knob on the 

back of the mic.

To...

Do this...

Transmit and Receive

Press PTT to transmit. Release PTT to listen for a response. 

The PTT button is located on the side of the mic.
If the wireless connection is lost, the mic sounds an error 

tone if PTT is pressed.

Increase/Decrease 

Volume

Press + to increase or − to decrease the volume in 16 

step increments. When you reach the 16th step in either 

direction, an error tone sounds.

Find a lost mic

1.  Press FIND on the cradle.
2.  When you locate the mic, press FIND on the cradle 

again or any key on the mic.

3.  The tone times out after 1 minute. 

When you turn off the car, the CB is also turned off. If the wireless mic has not been 

turned off, press SYNC/Power On/Off to turn it off; otherwise, it will automatically power off 

after 2 minutes.
The wireless mic will also power off if the mic is out of range for 2 minutes.

1.  While the battery pack charges in the mic, press and hold SYNC/Power On/Off for 

about 5 seconds.

2.  The mic beeps. 

3.  After the battery is charged, the LED alternately flashes orange and green.
There are three methods to turn the features back on. You can press SYNC/Power On/Off or 

you can press PTT.  You can also disconnect the mini-USB cable, and then reconnect it.

Speaker Output:  8 ohm
Operating Temp.:   14*F  ~ 122*F (-10*C ~  50*C)
Storage Temp.:  -4*F ~ 140*F  (-20*C ~ 60*C)
Ni-MH battery - BT-1008
Typical Battery Life:  8 hours
DC Charger Power Input:  10 - 16V DC
Digital Format:  DECT 6.0
Frequency Band:  1920 - 1930MHz

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) This device must accept any interference received, 
including interference that may cause undesired operation. Privacy of communications may not be ensured 
when using this device. 

Important: Evidence of original purchase is required for warranty service. 

WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”) 

ElEMENTS OF WARRANTY: Uniden warrants, for two years, to the original retail owner, this Uniden Product 
to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. 

WARRANTY dURATION: This warranty to the original user shall terminate and be of no further effect 
two years after the date of original retail sale. The warranty is invalid if the Product is (A) damaged or 
not maintained as reasonable or necessary, (B) modified, altered, or used as part of any conversion kits, 
subassemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired 
by someone other than an authorized Uniden service center for a defect or malfunction covered by this 
warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured 
by Uniden, or (F) installed or programmed by anyone other than as detailed by the owner’s manual for this 
product. 

STATEMENT OF REMEdY: In the event that the product does not conform to this warranty at any time 
while this warranty is in effect, warrantor will either, at its option, repair or replace the defective unit and 
return it to you without charge for parts, service, or any other cost (except shipping and handling) incurred 
by warrantor or its representatives in connection with the performance of this warranty. Warrantor, at its 
option, may replace the unit with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE 
IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES 
ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY 
OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY 
OR FITNESS FOR A PARTICULAR PURPOSE. THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE 
REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. 

Some states do not allow this exclusion or limitation of incidental or consequential damages so the above 
limitation or exclusion may not apply to you. 

lEgAl REMEdIES: This warranty gives you specific legal rights, and you may also have other rights which 
vary from state to state. This warranty is void outside the United States of America. 

PROCEdURE FOR OBTAININg PERFORMANCE OF WARRANTY: If, after following the instructions in the 
owner’s manual you are certain that the Product is defective, pack the Product carefully (preferably in its 
original packaging). The Product should include all parts and accessories originally packaged with the 
Product. Include evidence of original purchase and a note describing the defect that has caused you to 
return it. The Product should be shipped freight prepaid, by traceable means, to warrantor at: 

Uniden America Corporation  
Parts and Service Division  
4700 Amon Carter Blvd  
Fort Worth, TX 76155 

(800) 297-1023, 8 a.m. to 5 p.m., Central, Monday through Friday 

 x Speaker and Microphone in a 

single unit

 x Secure Sync
 x Push-To-Talk Control Button
 x Volume UP/Down Controls
 x Auto power-off 
 x Three-color LED control
 x Find button
 x Up to 100 meter range
 x Belt clip
 x Car charger plug with mini-USB 

connection

© 2013   Uniden America Corp. 

Printed in Vietnam

Ft. Worth, Texas  76155 

U01UU033ZZZ(0)