Honeywell International Inc. 9PGTPA-100A Manuale Utente
Page 2039
1 Dec 2003
34-45-4
7
MAINTENANCE MANUAL
CAS-100 COLLISION AVOIDANCE SYSTEM
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
5 Operate applicable aircraft circuit breakers to apply the power to TCAS
processor, traffic and resolution advisory displays, Mode S transponder
subsystem, and all other aircraft equipment connected to the TCAS processor
and Mode S transponder subsystem. Check that circuit breakers stay closed.
subsystem, and all other aircraft equipment connected to the TCAS processor
and Mode S transponder subsystem. Check that circuit breakers stay closed.
6 Let enough time for the equipment warm-up. The equipment in the TCAS
system requires one minute for the equipment warm-up. The external sensors
can necessary more than one minute warm-up time
can necessary more than one minute warm-up time
(b) Manual Test
1 On the traffic display screen, TCAS STBY mode annunciation must be visible.
2 Check that the brightness of the traffic display can be controlled by the applicable
control. Intensity of the traffic display on the TA/VSI is controlled by the aircraft
dimmer switch. Intensity of the traffic display on the PPI or dedicated display is
controlled by the BRT control on the display control panel.
dimmer switch. Intensity of the traffic display on the PPI or dedicated display is
controlled by the BRT control on the display control panel.
3 On the transponder/TCAS control unit, the ATC FAIL lamp must extinguished.
4 On transponder/TCAS control unit, turn the function selector switch to TA
position. The following conditions must be:
a Traffic display shows TA ONLY.
b RA OFF flag is present on RA/VSI.
c
Transponder/TCAS control panel ATC FAIL lamp is
extinguished.
extinguished.
d TA/VSI and RA/VSI red and green eyebrows are
extinguished.
e No fault or fail annunciations are present on the traffic display.
f
TA/VSI and RA/VSI vertical speed needle shows 0 vertical
speed.
speed.
g The traffic can be shown on the traffic display is necessary for
TCAS processor strapping configuration and if traffic is in the
area:
area:
•
Nonthreat Traffic, shown as an open white diamond.
•
Proximity Intruder traffic, shown as a filled white diamond.
•
Traffic Advisory (TA) traffic, shown as a filled yellow circle.
NOTE: Other than for the TEST mode, Resolution Advisory
(RA) traffic is never shown while the aircraft is on the
ground. The RA symbol is a solid red square.
ground. The RA symbol is a solid red square.