Honeywell International Inc. 9PGTPA-100A Manuale Utente
MAINTENANCE MANUAL
CAS-100 COLLISION AVOIDANCE SYSTEM
Page 2106
1 Dec 2003
34-45-4
7
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
NOTES: (cont)
7.
7.
DISPLAY STATUS INPUTS NO. 1 (RMP-14C) AND NO. 2 (RMP-13E) MUST BE CONNECTED
TO THEIR RELATED RA OR TA VSI [IVA-81 ( )] DISPLAY STATUS OUTPUT (VALID).
TO THEIR RELATED RA OR TA VSI [IVA-81 ( )] DISPLAY STATUS OUTPUT (VALID).
8.
THE AIRCRAFT ALTITUDE LIMIT IS ENCODED IN BINARY FORM USING A COMBINATION
OF THESE STRAPS. STRAP LOGIC: PINS JUMPERED TO THE COMMON, RMP-6K.
TOGETHER EQUAL THE ALTITUDE LIMIT. ALL PINS OPEN = 0 FEET
OF THESE STRAPS. STRAP LOGIC: PINS JUMPERED TO THE COMMON, RMP-6K.
TOGETHER EQUAL THE ALTITUDE LIMIT. ALL PINS OPEN = 0 FEET
9.
RBP-6B GROUND = DATA WILL BE LOADED INTO THE I/O PROCESSOR EEPROM
MEMORY
OPEN = DATA WILL BE LOADED INTO THE DATA PROCESSOR EEPROM MEMORY
MEMORY
OPEN = DATA WILL BE LOADED INTO THE DATA PROCESSOR EEPROM MEMORY
10. RBP-6C = SPARE PIN
11. OPEN = DRIVES AURAL ADVISORY DISCRETE OUTPUT
11. OPEN = DRIVES AURAL ADVISORY DISCRETE OUTPUT
PIN TO RBP-7K = 1 SECOND DELAY ADDED TO VOICE ADVISORY WITH RESPECT TO
AURAL ADVISORY.
AURAL ADVISORY.
12. ACTIVE STATE GROUND WILL PUT TCAS INTO STANDBY (SL = 1).
13. ACTIVE STATE GROUND WILL PUT TCAS INTO "TA ONLY" MODE (SL=2) AND PREVENT
13. ACTIVE STATE GROUND WILL PUT TCAS INTO "TA ONLY" MODE (SL=2) AND PREVENT
VIDEO AND AURAL ADVISORIES DUE TO ADVISORIES FROM OTHER HIGHER PRIORITY
SYSTEMS SUCH AS GROUND PROXIMITY AND WIND SHEAR WARNING SYSTEMS.
SYSTEMS SUCH AS GROUND PROXIMITY AND WIND SHEAR WARNING SYSTEMS.
14. THE DISPLAY STATUS INPUT NO. 3 (RMP-7E) OR NO. 4 (RMP-7J) MUST BE CONNECTED
TO THE TRAFFIC DISPLAY STATUS OUTPUT (VALID). IF DISPLAY STATUS NO. 3 OR NO.
4 ARE NOT USED, THEN THOSE PINS MUST BE GROUNDED TO PREVENT THE
UNWANTED FAILURES FROM BEING LOGGED IN THE MAINTENANCE DATA OUTPUT.
4 ARE NOT USED, THEN THOSE PINS MUST BE GROUNDED TO PREVENT THE
UNWANTED FAILURES FROM BEING LOGGED IN THE MAINTENANCE DATA OUTPUT.
15. THE AUDIO LEVEL FINDS THE SPEAKER AND PHONES AUDIO OUTPUT LEVEL BY
STRAPPING ONE OR MORE OF THESE PROGRAM PINS TO RBP-7K AS SHOWN BELOW.
1 = OPEN, 0 = CONNECTED TO RBP-7K
CAS-100 Interwiring Diagram
Figure 2015 (Sheet 12 of 16)
1 2 3
Phones Output
Speaker Output
DBM
MW
WATTS
DBM
*1 1 1
16
40
4.0
6
1 1 0
13
20
2.0
3
1 0 1
10
10
1.0
0
1 0 0
7
5
0.5
-3
0 1 1
5
3
0.3
-5.2
0 1 0
5
3
0.3
-5.2
0 0 1
5
3
0.3
-5.2
0 0 0
19
80
8.0
9
* Refer to Note 20.