Honeywell International Inc. 9PGTPL-100A Manuale Utente
Page 1008
1 Mar 2006
34-45-54
MAINTENANCE MANUAL
TPL-100A Processor / Part No. 940-0530-001
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
Table 1003. Mode S Line Maintenance Troubleshooting Procedure
(Fault Indication on PPI or Dedicated Display)
Fault Annunciation
Remedy
XPNDR TOP ANT
XPNDR LOWER ANT
Check:
Coaxial connectors
Coax cable
Coax switches
Coax switch circuit defective
Transponder antenna
No. 1 XPNDR ALT DATA
No. 2 XPNDR ALT DATA
XPNDR ALT DATA No. 1 and No. 2
Check:
Altitude source
Associated wiring
SELECTED XPNDR
XPNDR CONTROL DATA
Check Mode S transponder/control unit - Denotes
loss/incorrect data not covered by other fault codes
XPNDR TCAS DATA
No. 1 XPNDR DATA BUS
No. 2 XPNDR DATA BUS
Check:
Max airspeed program pins
Data bus wires (4)
Mode S address wires
Suppression coax cable
Power wires/circuit breaker
NOTE: If a fault is indicated, perform a front-panel test of the Mode S transponder unit for further clarification of these
problems.
Table 1004. TCAS Line Maintenance Troubleshooting Procedure
(Fault Indication on PPI or Dedicated Display)
Fault Annunciation
Remedy
MILACAS-FR
PROCESSOR
UPPER ANTENNA
LOWER ANTENNA
ATTITUDE
HEADING
LOWER ANTENNA
ATTITUDE
HEADING
Perform
MILACAS-FR
Processor self test
Refer to
paragraph 1.F.
TCAS FAIL/NO TCAS
TRAFFIC DISPLAY
TRAFFIC DISPLAY
PPI or dedicated display failure.
RA DISPLAY No. 1
A single RA DISPLAY or RADIO ALT FAULT are not annunciated in a
dual system unless other faults are present.
dual system unless other faults are present.
RA DISPLAY No. 2
RA DISPLAY No. 1 and No. 2
RA DISPLAY No. 1 and No. 2
Check ADCs, VSIs, wiring, power.
RADIO ALT No. 1 and No. 2
TD FAIL
TD FAIL
Check both radio altimeters.
PPI failed.
PPI failed.