Sharp Corporation HRO00171 Manuale Utente

is15sh_e_18.fm
[73/79]

■ Loudness Warning

Excessive sound pressure from earphones and headphones can cause hearing 

loss.

■ Headphone Signal Level

The maximum output voltage for the music player function, measured in 

accordance with EN 50332-2, is 36 mV.

■ European RF Exposure Information

Your mobile device is a radio transmitter and receiver. It is designed not to 

exceed the limits for exposure to radio waves recommended by international 

guidelines. These guidelines were developed by the independent scientific 

organization ICNIRP and include safety margins designed to assure the 

protection of all persons, regardless of age and health.

The guidelines use a unit of measurement known as the Specific Absorption Rate, 

or SAR. The SAR limit for mobile devices is 2 W/k

g and the highest SAR value for 

this device when tested at the ear was 0.248 W/k

g

*

.

As SAR is measured utilizing the devices highest transmitting power the actual 

SAR of this device while operating is typically below that indicated above. This is 

due to automatic changes to the power level of the device to ensure it only uses 

the minimum level required to reach the network.

The World Health Organization has stated that present scientific information does 

not indicate the need for any special precautions for the use of mobile devices. 

They note that if you want to reduce your exposure then you can do so by limiting 

the length of calls or using a hands-free device to keep the mobile phone away 

from the head.

-

This device complies with part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause 
undesired operation.

-

Changes or modifications not expressly approved by the manufacturer 
responsible for compliance could void the user’s authority to operate the 
equipment.

■ Information to User

This equipment has been tested and found to comply with the limits of a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular 

installation; if this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user 

is encouraged to try to correct the interference by one or more of the following 

measures:

1.

Reorient/relocate the receiving antenna.

2.

Increase the separation between the equipment and receiver.

3.

Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected.

4.

Consult the dealer or an experienced radio/TV technician for help.

* The tests are carried out in accordance with international guidelines for testing.

is15sh_e.book  73 ページ  ２０１２年６月８日　金曜日　午後３時５４分