Sharp Corporation NAR0059 Manuale Utente
Operation Manual
4-1
4
CHAPTER 4
Communication Functions
This chapter explains how to use the LAN, wireless LAN, and built-in modem
functions.
functions.
• When you use communication software:
• Connect the computer to the AC power source.
• Do not allow the computer enter a system standby or system
• Do not allow the computer enter a system standby or system
hibernation mode. (See the Power Saving section on page 2-7.)
• See also the manual or online help of the software you are using.
• The communication speed may vary depending on the traffic, local
telecommunications infrastructure, and ISP (Internet Service
Provider) infrastructure.
Provider) infrastructure.
Local Area Network (LAN)
You can connect to a LAN with the 100 Base-TX or 10 Base-T connector on the
computer. To activate the LAN, perform the following steps.
Never insert any other cables, but a LAN cable, which may have different
electric characteristics from those of the LAN cable. Otherwise, the LAN
and the cables may be damaged.
electric characteristics from those of the LAN cable. Otherwise, the LAN
and the cables may be damaged.
Use the appropriate cable for each LAN standard.
100 Base-TX : Category 5 or higher
10 Base-T : Category 3 or higher
100 Base-TX : Category 5 or higher
10 Base-T : Category 3 or higher