Nokia of America Corporation BBTRX-06 Manuale Utente
...................................................................................................................................................................................................
3
Replace the sliding retainer extrusion on each pole band so that the beveled ends of
extrusion faces the open end of the band.
extrusion faces the open end of the band.
Bend the bands
Perform the following procedure to bend the upper and lower pole bands.
...................................................................................................................................................................................................
1
Bend the bands at the previously marked spot so that the pointed end of the band will be
inside the band after installation.
inside the band after installation.
...................................................................................................................................................................................................
2
Strike the bands with a hammer to create a sharp radius that allows the retainer to lock
into place.
into place.
...................................................................................................................................................................................................
3
Make a 90 degree bend at the base of each retainer extrusion to allow the retainers and
carriage bolt to properly align and lock into place.
carriage bolt to properly align and lock into place.
Install pole bands on pole
Perform the following procedure to install the upper and lower pole bands on the pole.
...................................................................................................................................................................................................
1
Place the pole bands around the pole at the determined height.
...................................................................................................................................................................................................
2
Insert the carriage bolt through both retainers, making sure that the head of bolt properly
locks into the fixed retainer.
locks into the fixed retainer.
...................................................................................................................................................................................................
3
Install the nut and tighten it just enough so that the band and weldment(s) maintain their
position on the pole. Do not fully tighten the nut.
position on the pole. Do not fully tighten the nut.
...................................................................................................................................................................................................
4
Adjust the position of the weldment(s) so that they are centered on the horizontal and
vertical lines marked on the pole.
vertical lines marked on the pole.
Transport, mount, and ground the RRH
Mounting instructions
Mounting instructions
To mount hardware to pole with pole bands
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
5-20
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
FDD RRH 700L
3MN-00075-0002-RJZZA
Issue 0
September 2012
E
N D
O F
S T E P S
...................................................................................................................................................................................................
E
N D
O F
S T E P S
...................................................................................................................................................................................................