Raytheon Anschuetz GmbH High Seas Products MTX9 Manuale Utente

Chapter 2: Installing the Scanner

Connecting the open array scanner inter-unit cable

CAUTION:
Before wiring the scanner unit check that it is securely mounted to the
platform, then make sure that the inter-unit cable is not connected and
power is not applied to the display unit. The scanner switch must be in the
OFF position.

1. Loosen the four self-retaining bolts securing the pedestal lid to the base.

Pull-up and turn the bolts anti-clockwise to lock them in the upright
position. Remove the lifting eyes.

Note: It is important to remove lifting eyes to avoid corrosion. Retain the lifting
eyes: they will be required if the scanner is removed from its platform.

2. Open the pedestal lid. Ensure the securing stay has automatically locked

into position.

3. Referring to the following illustration, remove the cable gland nut, washer

and grommet from the watertight gland, where the inter-unit cable will
enter the base.

4. Slide the cable through the gland nut, washer and grommet, then into the

base. Clamp into position, ensuring the section of main cable covered in
yellow heatshrink is clamped.

D4575-1

20mm (0.8in)

40mm (1.6in)

20mm (0.8in)

5mm (0.2in)

Heatshrink

154_3c2.p65

13/12/99, 17:02