Raytheon Anschuetz GmbH High Seas Products MTX9 Manuale Utente
Preface
iii
Preface
This handbook describes the following Pathfinder radar scanners from
Raytheon:
Raytheon:
2D
18" 2 kW Radome Scanner
4D
24" 4 kW Radome Scanner
5S
48" 4 kW Open Array Scanner
48" 10 kW Open Array Scanner
48" 10 kW Open Array Scanner
2D, 4D and 5S scanner units may be connected to RL70, RL70RC, R70, or
R70RC display units. In addition the 2D and 4D scanner units may be
connected to SL70, or Autohelm 7" LCD display.
R70RC display units. In addition the 2D and 4D scanner units may be
connected to SL70, or Autohelm 7" LCD display.
CAUTION
The 5S 48" Open Array Scanner must not be used with the SL70 or
Autohelm 7” LCD Display Unit. This may result in damage to the display
due to the high power requirements of the open array scanner.
The 5S 48" Open Array Scanner must not be used with the SL70 or
Autohelm 7” LCD Display Unit. This may result in damage to the display
due to the high power requirements of the open array scanner.
The handbook contains very important information on the installation and
operation of your new equipment. In order to obtain the best results in operation
and performance, please read this handbook thoroughly.
operation of your new equipment. In order to obtain the best results in operation
and performance, please read this handbook thoroughly.
Raytheon’s Product Support representatives or your local dealer will be
available to answer any questions you may have.
available to answer any questions you may have.
Display Software Version
For full operation of the open array scanners, the display software version must
be 4.xx (or higher) for a R70/R70RC, or 5.xx (or higher) for a RL70/RL70RC.
These software versions are normally already installed in the display unit and
are also fully compatible with the 2D and 4D radome scanners.
be 4.xx (or higher) for a R70/R70RC, or 5.xx (or higher) for a RL70/RL70RC.
These software versions are normally already installed in the display unit and
are also fully compatible with the 2D and 4D radome scanners.
Early display units may not have the correct software for use with open array
scanners and will therefore require upgrading.
The software version can be confirmed by switching-on the display and
checking the version number during the magnetron warm-up sequence.
Note that if a scanner unit is not connected then the version number is only
displayed for 10 seconds.
scanners and will therefore require upgrading.
The software version can be confirmed by switching-on the display and
checking the version number during the magnetron warm-up sequence.
Note that if a scanner unit is not connected then the version number is only
displayed for 10 seconds.
We recommend that where a repeater display is fitted, both the repeater and the
master display are upgraded.
master display are upgraded.
Where, necessary Software Upgrade Kits are available from your dealer,
distributor or from Raytheon Marine, Part Nos. R55020 (R70/R70RC) and
R55019 (RL70/RL70RC).
distributor or from Raytheon Marine, Part Nos. R55020 (R70/R70RC) and
R55019 (RL70/RL70RC).
154_3pre.p65
13/12/99, 17:01
3