Honeywell International Inc. KTR2280 Manuale Utente
n
KTR 2280 Preliminary H 08/17/06
Rev. 0, Aug/2006
©Honeywell International Inc. Do not print without express permission of Honeywell
Page 2-1
SECTION 2
INSTALLATION
2.1 GENERAL INFORMATION
This section contains general suggestions and information to consider before installation
of the KXP 2290. Close adherence to these suggestions will assure optimum performance
from the equipment.
of the KXP 2290. Close adherence to these suggestions will assure optimum performance
from the equipment.
NOTE: The conditions and test required for the TSO/ETSO and MOPS approval of this
article are minimum performance standards. It is the responsibility of those
installing this article either on or with a specified type or class of aircraft to
determine that the aircraft installation conditions are within the TSO/ETSO and
MOPS standards. These articles must have separate approval for installation in
an aircraft. Any features in this equipment outside the requirements of this
applicable TSO/ETSO and MOPS must be evaluated and approved as part of the
installation approval. The article may be installed only if further evaluation by the
applicant confirms that the installation is acceptable and is approved by the
Administrator.
installing this article either on or with a specified type or class of aircraft to
determine that the aircraft installation conditions are within the TSO/ETSO and
MOPS standards. These articles must have separate approval for installation in
an aircraft. Any features in this equipment outside the requirements of this
applicable TSO/ETSO and MOPS must be evaluated and approved as part of the
installation approval. The article may be installed only if further evaluation by the
applicant confirms that the installation is acceptable and is approved by the
Administrator.
2.2 UNPACKING AND INSPECTING EQUIPMENT
Exercise extreme care when unpacking the equipment. Make a visual inspection of the
unit for evidence of damage during shipment. If a claim for damage is to be made, save
the shipping container to substantiate the claim. The claim should be promptly filed with
the transportation company. It would be advisable to retain the container and packing
material after all equipment has been removed, in the event that equipment storage or
reshipment should become necessary.
unit for evidence of damage during shipment. If a claim for damage is to be made, save
the shipping container to substantiate the claim. The claim should be promptly filed with
the transportation company. It would be advisable to retain the container and packing
material after all equipment has been removed, in the event that equipment storage or
reshipment should become necessary.
2.3 EQUIPMENT INSTALLATION
2.3.1 AVIONICS COOLING REQUIREMENTS
The unit is cooled by a fan internal to the unit and one attached to the rear rack assembly
plate, the latter being a part of the installation (see
plate, the latter being a part of the installation (see
). During installation, do not block any holes in the unit
cover(s) which would restrict air flow.
2.3.2 EQUIPMENT LOCATION
The following paragraphs contain information pertaining to the initial installation of the
KTR 2280 MMDR, including instructions concerning the location and mounting of the
supporting antenna(s).
KTR 2280 MMDR, including instructions concerning the location and mounting of the
supporting antenna(s).