Honeywell International Inc. WFSPS Manuale Utente

18

SWIFT® Smart Wireless Integrated Fire Technology Manual — P/N LS10036-000NF-E:E 11/9/2017

FWSG FlashScan Wireless System Gateway

The profile is removed and the gateway is reset to factory default state.

To create a mesh network using the SWIFT Tools, perform the following steps.
1.

Connect the W-USB adapter to your laptop. For more information on the USB adapter, refer to Section 5, “USB Adapter”, on page 

2.

Launch SWIFT Tools. Refer to Appendix A for more information.

3.

From the Home Screen, select the Create Mesh Network function.

4.

Proceed to the second step of the Create Mesh Network function by clicking the arrow marked Next at the top of the screen.

5.

Click to select the desired gateway displayed in the Gateways in Range table and then click Start Mesh Formation.

While the mesh is formed, SWIFT Tools helps track the number of devices that have joined the mesh and view the progress. Mesh for-

mation terminates 10 minutes after the last device joins the mesh. In addition, mesh formation can be manually terminated by clicking 
the Start Mesh Restructuring button.
Once mesh formation is complete, the network automatically transitions to restructure the mesh. For further operating instructions, refer 

There are two ways to initiate profile distribution from the gateway.
•

Automatically after creating a profile if the profile was not created by SWIFT Tools

•

Activating the profile-creating magnetic sensor when the gateway has a profile.

Profile distribution is automatically enabled from the gateway after creating a profile using either magnetic sensor upon the gateway’s 

start-up. The profile distribution automatically terminates after 10 minutes. 

re

se

tde

vices.jp

g

m

esho

p

to

ols.p

n

g