Canon 812 Manuale Utente
FCC Notice for model: WM812
Following statement must be included in the user manual of host device.
The end product must be labeled ''Contains FCC ID: AZD812''
FCC/IC NOTICE
Model: PC2036 (including WLAN Module Model WM812, FCC ID: AZD812)
Model: PC2036 (including WLAN Module Model WM812, FCC ID: AZD812)
This device complies with Part 15 of FCC Rules and Industry Canada licence‐exempt RSS standard(s).
This device complies with Part 15 of FCC Rules and Industry Canada licence‐exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of this device.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of this device.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or modifications
should be made, you could be required to stop operation of the equipment.
should be made, you could be required to stop operation of the equipment.
This transmitter must not be co‐located or operated in conjunction with any other antenna or transmitter
except Canon accessories supplied or designated for this product.
except Canon accessories supplied or designated for this product.
The available scientific evidence does not show that any health problems are associated with using low power wireless devices. There is
no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio
frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue),
exposure of low‐level RF that does not produce heating effects causes no known adverse health effects. Many studies of low‐level RF
exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings
have not been confirmed by additional research. This model has been tested and found to comply with FCC/IC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and
no proof, however, that these low power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio
frequency energy (RF) in the microwave range while being used. Whereas high levels of RF can produce health effects (by heating tissue),
exposure of low‐level RF that does not produce heating effects causes no known adverse health effects. Many studies of low‐level RF
exposures have not found any biological effects. Some studies have suggested that some biological effects might occur, but such findings
have not been confirmed by additional research. This model has been tested and found to comply with FCC/IC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and
Following statement must be included in the user manual of the host device.
Because the host device is so small that it is not practicable to place the following statement on it.
Because the host device is so small that it is not practicable to place the following statement on it.
have not been confirmed by additional research. This model has been tested and found to comply with FCC/IC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and
RSS‐102 of the IC radio frequency (RF) Exposure rules.
set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and
RSS‐102 of the IC radio frequency (RF) Exposure rules.
This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may not cause
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.