The Genie Company a Division of Overhead Door Corporation G1TA Manuale Utente

15

Force settings are pre-programmed at the factory and applied  

during the Open/Closed Limit settings steps (see page 8). For  normal 

use, these settings should not need adjustments with this unit.

See pages 8-9 to reset travel limits. Force setting and contact reverse test must be performed in the event of a travel limit change.

!

NE JAMAIS régler la force pour compenser des dommages, 

y compris une porte mal équilibrée, un rail de porte coinçant 

ou des ressorts cassés.

•

Tous les mois, EFFECTUEZ LE TEST D’INVERSION AU CONTACT. 

Voir page 10.

!

NEVER adjust the force settings to adjust for damage,   
including an unbalanced door, binding door track or    
broken spring.

•

Perform a CONTACT REVERSE TEST monthly. See page 10.

Conditions possibly requiring adjustments are: 

1. Doors with very stiff weather seals. 

2. Doors that start down, STOP, and reverse before closing. 

3. Doors that start up, but STOP before they completely open.

 

PROGRAM

SET

   

 

Press and hold both up and 

down arrow buttons until 

round LED turns RED, release 

buttons. Round BLUE LED will 

flash 3 times.

 LEDs will now display current UP force setting (See chart).

Press either arrow button until 

desired UP force setting is 

reached.

See Chart

Once setting is chosen, press 

and release. This will lock the 

UP force setting. 

LEDs will now show current DOWN force setting. (See Chart).

Press either arrow button until 

desired DOWN force setting is 

reached. 

See Chart

Once setting is chosen, press 

and release. This will lock the 

DOWN force setting. 
The LEDs will now turn BLUE then off. This confirms 

that both force settings have been set and unit is 

ready for normal operation.
Repeat “Learn Force Limits and Contact Reverse Test” page 10

OFF

BLUE

BLUE

OFFFlashes 

3 Times

OFF

RED

BLUE

 

PROGRAM

SET

   

 

 

PROGRAM

SET

   

 

 

PROGRAM

SET

   

 

 

PROGRAM

SET