GN Audio USA Inc. GN7170 Manuale Utente

English

FCC Notice to Users/Product Statements

This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions:

(1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may

cause undesired operation.

Users are not permitted to make changes or modify the device in any way.

Warning: Changes or modifications not expressly approved by GN Netcom

will void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the lim-

its for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harm-

ful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television re-

ception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more

of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

The user must place the base at least 8” (20cm) or more from any per-

sonnel and must not be co-loaded or operating in conjunction with any

other antenna or transmitter in order to comply with FCC RF exposure 

requirements.

This equipment complies with Part 68 of the FCC Rules and the require-

ments adopted by ACTA. On the bottom of this equipment is a label that

contains, among other information, a product identifier in the format US:

AAAEQ##TXXXX (see list at the end of this statement). If requested, this

number must be provided to the telephone company.

This equipment connects to (USOC) RJ11C modular jacks for network 

connection.

A plug and jack used to connect this equipment to the premises wiring

and telephone network must comply with the applicable FCC Part 68 rules

and requirements adopted by ACTA. A compliant telephone and plug is

provided with this product. It is designed to be connected to a compati-

ble modular jack that is also compliant.

The REN is used to determine the number of devices that may be con-

nected to a telephone line. Excessive RENs on a telephone line may

result in the devices not ringing in response to an incoming call. In most

but not all areas, the sum of the RENs should not exceed (5.0). To be

certain of the number of devices that may be connected to a line, as

determined by the total RENs, contact the local telephone company.

If your home has specialty wired alarm equipment connected to the tele-

phone line, ensure the installation of this device does not disable your

alarm equipment. If you have questions about what will disable alarm

equipment, consult your telephone company or a qualified installer.

If this equipment causes harm to the telephone network, the telephone

company will notify you in advance that temporary discontinuance of

service may be required. But if advance notice isn’t practical, the tele-

phone company will notify the customer as soon as possible. Also, you

will be advised of your right to file a complaint with the FCC if you believe

it is necessary.

The telephone company may make changes in its facilities, equipment,

operations or procedures that could affect the operation of the equip-

ment. If this happens the telephone company will provide advanced 

Warranty_170x135_US_B  26/08/04  13:17  Side 3