Marvelworks Limited DE300 Manuale Utente
E. Channel selection:
1. The transmitter and receiver have been set to the same channel when ex-factory. They are ready to use without having to pair.
If there is interference from other wireless device, you can change the channel. There are 16 channels for you to choose.
2. To change the channel, remove the back of the transmitter using paperclip or slotted screw driver, twist to open the lock (see
figure below). Change the setting on the channel switch in any of the 16 combinations. Replace the back of the transmitter.
3. Open the battery compartment of the receiver, change the channel to match the transmitter.
4. Make sure the ON/OFF switch on the receiver is "ON" position.
4. Make sure the ON/OFF switch on the receiver is "ON" position.
F. Low battery indicator
When the batteries are exhausted, the LED will flash 3 times every 10 seconds.
G. Changing the batteries for the Transmitter
H. Power by adaptor
I. Cleaning
1. Transmitter and Receiver: Use a dry cloth to wipe the surface. Do Not immerse in water.
2. Sensor: Use a damp cloth to wipe the sensor tip and let it dry naturally.
( Note: The sensor should be cleaned regularly so as to maintain its sensitivity. )
2. Sensor: Use a damp cloth to wipe the sensor tip and let it dry naturally.
( Note: The sensor should be cleaned regularly so as to maintain its sensitivity. )
J. Useful tips
1. You are recommended to have a trial run of all steps for use of the alarm during day time with your child before the first time
use.
2. Rapid response to the alarm alert can enhance the success rate in overcoming bedwetting. Parents play an important role,
3. Keep using the alarm for 2 more weeks after dryness so as to lower the chance of relapse.
K. One-year warranty
We offer you a one-year warranty for manufacturer's defects. For details, please visit our website or contact us by email.
Website: www.bedwettingsolving.com
Email: info@bedwettingsolving.com
© Marvelworks Ltd.
The transmitter consumes very little power so the batteries are very long-lasting. In case you need to replace the batteries, just
open the back of the transmitter with paperclip or slotted screw driver (see figure above).
open the back of the transmitter with paperclip or slotted screw driver (see figure above).
The receiver can be powered by 2 AA batteries or any smart phone adaptor (with output voltage: 5Vdc ; current: 0.5A or above).
To use an adaptor (not included), connect the receiver and the adatpor with the USB cord provided.
To use an adaptor (not included), connect the receiver and the adatpor with the USB cord provided.
in particular at the initial stage, in awakening a sleeping child for urination and are therefore recommended to sleep in the same
room with the child for the first 2 weeks of using the alarm.
room with the child for the first 2 weeks of using the alarm.