Bosch Security Systems BV NDE8000 Manuale Utente

FLEXIDOME IP starlight 8000i

Hardware Installation | en

Bosch Security Systems

Installation Manual

2018.11 | 01 |

1.

For 

on-ceiling cable routing, the cable conduit must be oriented towards the cable duct.

(Preliminary picture)

1.

Use the mounting plate to mark the bore holes on the surface. Note: With in-ceiling cable

routing, make sure to have the plate centered over the cable outlet. The cable will be

passed through the center hole. The cabling must not get stuck between the surface and

the plate!

2.

Drill four holes. Choose the right holes combination for your application.

3.

Place your wall plugs or anchors.

4.

For in-ceiling cabling only: pass the cable through the center hole of the surface mounting
plate.

5.

Place the plate onto the bore holes. Make sure to proper align to the correct holes on the

plate.

6.

Fasten the screws or studs. Torque for fastening must exceed 4 NM and shall not exceed

7 NM.

7.

Check for firm hold of the plate.

Fixing the surface mounting plate is finished.

To maintain the IK10+ rating of the installation, screws or anchors used must meet the

following specifications:

–

Use no less than 4 screws or studs.

–

Only use the appropriate holes. Do not use the long slots in the plate for mounting.

–

Use 5mm screws and wall plugs or M5 anchor bolts only.

The surface mounting plate in its delivery state can be used for 

in-ceiling cable routing without

further configuration.

To prepare for connecting to the camera base: Use the hooks on the surface mounting plate to

secure the cable and to form a service loop. Note: excessive cable lengths (> 30 cm) will not

fit into the confined space between camera base and surface mounting plate.