Bosch Security Systems BV NDE8000 Manuale Utente

en | Troubleshooting

FLEXIDOME IP starlight 8000i

2018.11 | 01 |

Installation Manual

Bosch Security Systems

The following table is intended to help identify the causes of malfunctions and correct them

where possible.

Unit does not operate.

Power failure.

Check power supply.

Faulty cable connections.

Check all cables, plugs,

contacts and connections.

No connection

established, no image

transmission.

Incorrect unit configuration.

Check all configuration

parameters (reset to factory

default if necessary).

Faulty installation.

Check all cables, plugs,

contacts and connections.

Wrong IP address.

Check the IP addresses (ping).

Faulty data transmission within

the LAN.

Check the data transmission

with ping.

The maximum number of

connections has been reached.

Wait until there is a free

connection and call the

transmitter again.

No audio transmission to

remote station.

Hardware fault.

Check that all connected audio

units are operating correctly.

Faulty cable connections.

Check all cables, plugs,

contacts and connections.

Incorrect configuration.

Check audio parameters on the

Audio configuration and LIVE

page functions pages.

The audio voice connection is

already in use by another

receiver.

Wait until the connection is free

and then call the sender again.

The unit does not report

an alarm.

Alarm source is not selected.

Select possible alarm sources

on the Alarm sources

configuration page.

No alarm response specified.

Specify the desired alarm

response on the Alarm

connections configuration page;

if necessary change the IP

address.

The unit is not

operational after a

firmware upload.

Power failure during

programming by firmware file.

Have the unit checked by

Customer Service and replace if

necessary.