Shenzhen HC Tech Co. Ltd. 2017JVCI Manuale Utente
14
Cross-shaped Signal Pin
The Cross-shaped signal pin is used to place MCU board, MCU spare cable
or DIY signal cable to read or write MCU and ECU chips.
or DIY signal cable to read or write MCU and ECU chips.
IC Card Induction Area
It is used to read and write IC card information.
Vehicle Key Slot
It is used to hold the vehicle key to read or write vehicle key information.
Transponder Slot
It is used to hold the transponder to read or write transponder information.
Remote Control Transponder Induction Area
It is used to read and write remote control transponder information.
Mercedes Infrared Key Slot
It is used to hold Mercedes infrared key to read or write Mercedes vehicle key
information.
information.
Status LED
The Status Indicator shows the current operating status of the UP400. See
the table below for detailed description.
Table 2-8 Description of the Status LED
Indicator
Status
Description
On
Light Green
Powered on and default
Flash Green
Communication
Light Red
Error
Locker
It is used to place EEPROM chip or socket to read or write EEPROM
information.
information.