Vision Automotive Technology 819108 Manuale Utente
TPMS REPEATER SYSTEM - 819108
FITTING REPEATER
Repeater should be mounted to the A Frame of the trailer as close to the vehicle tow ball as possible using the hardware provided
POWERING THE REPEATER
BATTERIES
1) Remove battery cover by removing the 5 screws on the top
2) Insert the AA batteries provided and re-fit the battery cover
3) Ensure the seal is seated correctly and not twisted when re-fitting screws.
4) Do not over tighten screws. (screws should be hand tightened only)
2) Insert the AA batteries provided and re-fit the battery cover
3) Ensure the seal is seated correctly and not twisted when re-fitting screws.
4) Do not over tighten screws. (screws should be hand tightened only)
12V+ UPGRADE KIT - 819109
1) Remove battery cover by removing the 5 screws on the top
2) Plug 2 pin connector from upgrade kit into repeater as shown below
2) Plug 2 pin connector from upgrade kit into repeater as shown below
3) Refit 12V upgrade kit in place of battery cover
4) Using the 3 longer screws provided, screw upgrade kit into position as shown and use 2 of the previously removed screws in
4) Using the 3 longer screws provided, screw upgrade kit into position as shown and use 2 of the previously removed screws in
the remaining 2 holes