JL MARINE SYSTEMS INC. EA070 Manuale Utente
NOTE:
Only compatible with C-Monster 2.0.
Programming Instructions
Pairing Key-Fob Remote Control:
1.
Press and hold the PROGRAM button on the top of the
unit for 3 seconds until the LED turns green (HPU will also
beep). The unit is now ready to be paired with the key-fob
remote control.
beep). The unit is now ready to be paired with the key-fob
remote control.
NOTE:
If dual units are installed, repeat Steps 1–3 to pair
multiple units to a single remote control. Up to (10)
wireless controllers can be programmed to each unit.
wireless controllers can be programmed to each unit.
2.
Press the UP button on the key-fob remote control for
one second and release. The green LED on the unit will
initially turn off, then flash green steadily (HPU will also
beep) indicating that the pairing is complete.
initially turn off, then flash green steadily (HPU will also
beep) indicating that the pairing is complete.
3.
Test the paired remote control by pressing the UP
and the DOWN button to ensure that the anchor
is responding.
is responding.
To raise or lower the spike, press and hold either the UP or
DOWN
DOWN
button on the remote control. The anchor will only
continue to move so long as you keep the button depressed.
Auto Mode:
Double tapping (pressing and releasing 2
times within 1 second) either the UP or the DOWN
button on the remote control will cause the anchor
to retract or deploy automatically. The anchor will
continue to move in said direction until it either
retracts completely (up) or senses a solid bottom
surface (down).
button on the remote control will cause the anchor
to retract or deploy automatically. The anchor will
continue to move in said direction until it either
retracts completely (up) or senses a solid bottom
surface (down).
Battery Replacement:
1.
Ensure the surrounding area is as dry as possible to avoid
any moisture intrusion.
2.
Use a small screwdriver to remove the Key-Fob cover.
FIG. 1
3.
Remove the rubber membrane and the circuit board from
the Key-Fob.
4.
Remove the battery from the holder on the front of circuit
board and replace with any CR2032 3V Lithium Coin
Battery. FIG. 2
Battery. FIG. 2
5.
Place the circuit board and rubber membrane back into
the Key-Fob base and ensure that the rubber membrane
is seated properly prior to installing the cover. FIG. 3
is seated properly prior to installing the cover. FIG. 3
Operating Instructions
Figure 1
Figure 2
Figure 3
KEY FOB REMOTE CONTROL
INSTRUCTIONS
INSTRUCTIONS
PROGRAM button
LED
Hydraulic Pump Unit