RadioShack Corporation 2000424 Manuale Utente
20-424 Owner’s Manual
Page 19
WIRED PROGRAMMING
1. Turn off the scanner.
2. Connect the scanner to the PC using a PC cable.
3. While pressing
ENT
and
9
, turn on the scanner.
PGM
and
WirEd
appear. Then send the data from
the PC.
StArt
and the data being received by the scanner appears in the order it is received.
Notes:
• If the scanner receives no data from the PC for more than 20 seconds or if you press any key,
wired programming stops.
• If the scanner did not receive a start bit from the PC,
StArt
does not appear.
4. When the scanner successfully receives all data,
End
and
FiniSh
appear. If the scanner received
an error while receiving data,
End
and
d-Err
appear. If the scanner received a checksum error while
receiving data,
C-Err
and a number shown next to
C-Err
indicates the packet number where the
error occurred.
Notes:
• If the scanner did not receive an end bit from the PC,
End
does not appear.
• Wired programming stops if the scanner receives an empty channel number.
SPECIAL FEATURES
SPECIAL FUNCTION
Each search band (FD/PD, AIR, and HAM) and tune has one or two corresponding channel banks.
The following table shows the search bands and their corresponding channel banks.
Search Band
Channel Bank
Fire/Police
4, 5
Aircraft
6
Ham
7, 8
Tune
9, 10
While searching any search band (FD/PD, AIR, or HAM), when you find a transmission and if you
want to program it into the corresponding channel bank, the scanner programs it into a channel in
the corresponding channel bank by pressing
ENT
key.
If you want to scan the fire/police, air, or ham channels, press one touch search key (
FD/PD
,
AIR
, or