Motorola Solutions Inc. 99FT5101 Manuale Utente
76
MN002253A01-AD
Chapter 11: SLR 8000 Maintenance and Disassembly/Reassembly
Chapter 11: SLR 8000 Maintenance and Disassembly/Reassembly
4 Install a third M4 x 16 mm screw (PN: 0371274L02) at the mounting location at the other end of
the module to 15 lb-in.
Figure 82: Securing Power Supply to Base Station/Repeater Chassis
11.7.6
Replacing the Power Supply (for Base Station/Repeater with
Wireline Card)
Wireline Card)
This is an optional procedure. For a base station/repeater with a wireline card, perform the following.
Procedure:
1 Place the Power Supply module (PN: PMPN4053_) into the chassis.
2 Using a T20 Torx driver, install two M4 x 16 mm screws (PN: 0371274L02) through the back
panel clearance holes into the mounting points on the Power Supply module to 15 lb-in.
3 Install a third M4 x 16 mm screw (PN: 0371274L02) at the mounting location at the other end of
the module to 15 lb-in.
4 Place the Wireline card onto the Power Supply Module. Using a T15 Torx driver, install seven
M3.5 screws (PN: 0310909A45) into place as shown in the following figures.