Motorola Solutions Inc. 99FT5101 Manuale Utente

103 

MN002253A01-AD 

Chapter 13:  SLR 8000 Wireline 

 

 

 

There are only two options on the Wireline board that must be configured through jumpers. All other 
configuration settings are modified using the CPS. 

 

When operating the Wireline board in DC Remote Control mode, the jumpers on header P1200_3 must 
be set. These jumpers route DC Control currents from the correct Wireline pair to the DC Remote 
Decoder. 

NOTICE: For maximum audio performance, the jumpers should be removed when operating in 
Tone Remote Control or no remote control mode. 

The following table and figure shows the jumper configuration and location of jumpers on the P1200_3 
connector for the Wireline Interface Board. 

 

Table 51: Wireline Board Jumper Settings

 

 

No DC Remote 

No jumpers installed 

2-Wire DC Remote 

Jumper pins: 1 to 2, 3 to 4 

 

4-Wire DC Remote 

Jumper pins: 5 to 6, 7 to 8 

NOTICE: Do not simultaneously enable 2-Wire and 4-Wire DC Remote. 

 

When operating the SLR 8000 in an E&M configuration through the Wireline board, there are two 
modes to choose from. The E&M mode is selected through the jumper settings on header P2301_1. 
These jumpers select whether the Wireline board PTT function is electrically isolated or 
non-isolated. 

The following table and figure show the jumpers' configuration and location of jumpers on the P2301_1 
connector for the Wireline Interface Board. 

 

Table 52: Wireline Board Jumper Settings

 

 

Isolated 

3 to 5, 4 to 6 

Non-Isolated 

Jumper pins: 1 to 3, 2 to 4, 5 to 7, 6 to 8 

 

2 4 6 8

 

1 3 5 7