Motorola Solutions Inc. MCSERIESSC External Photos
APPLICANT: MOTOROLA
EQUIPMENT TYPE: ABZMCSERIESSC
FCC ID: ABZMCSERIESSC
Electrical Requirements: -48 VDC, 35 Amps
MADE IN MEXICO FABRIQUE AUX MEXICO
Certified to 47 CFR Part 90.691. Licensed operation required.
APPROVED Dimensions: This equipment complies with RF Exposure
Limits for Fixed Transmitters in accordance with 47 CFR Part 1.1310.
This device complies with part 15, class A of the FCC rules. Operation
is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference
received including interference that may cause undesired operation.
Model: MC Series Standard Capacity
November 23, 2010
To:
To:
Elite Electronic Engineering
Re: Identification
Change
for
iDEN Multi-Carrier– Standard Capacity Transmitter
Per CFR 47, Paragraph 2.933, Motorola respectfully requests a change in identification for the indicated
transmitter.
The affected transmitter is as follows:
Existing FCC ID
Lower (MHz)
Upper (MHz)
New FCC ID
PURMCSERIESSC 851.0125 868.9875 ABZMCSERIESSC
(1) The original identification used
The original identification used for the transmitter is PURMCSERIESSC. This is a multi-carrier transmitter that is
used in iDEN systems.
(2) The date of the original grant
The date of the original grant of equipment authorization is 02/28/2008.
(3) How the equipment bearing the modified identification differs from the original equipment
The change requested is in identification only. There is no change in design, circuitry, or construction of the unit
other than company logos and labeling. The front panels on the equipment have the Motorola logos rather than
the RadioFrame Networks logos. The identification label also contains ‘Motorola’ as well as the updated FCC
identification number, ABZMCSERIESSC.
(4) Whether the original test results continue to be representative / applicable
All original test results currently on file with the commission are applicable and are representative of current and
future shipping product. The equipment will be completely compatible and interchangeable with the existing
equipment previously shipped by RFN. The form, fit, and function of the equipment is identical.
(5) Exterior appearance photographs
An image of the new label is shown below. The FCC ID label goes on the inside surface of the bulkhead at the
top of the rack. External photographs of the unit are shown on the following page.
(1) The original identification used
The original identification used for the transmitter is PURMCSERIESSC. This is a multi-carrier transmitter that is
used in iDEN systems.
(2) The date of the original grant
The date of the original grant of equipment authorization is 02/28/2008.
(3) How the equipment bearing the modified identification differs from the original equipment
The change requested is in identification only. There is no change in design, circuitry, or construction of the unit
other than company logos and labeling. The front panels on the equipment have the Motorola logos rather than
the RadioFrame Networks logos. The identification label also contains ‘Motorola’ as well as the updated FCC
identification number, ABZMCSERIESSC.
(4) Whether the original test results continue to be representative / applicable
All original test results currently on file with the commission are applicable and are representative of current and
future shipping product. The equipment will be completely compatible and interchangeable with the existing
equipment previously shipped by RFN. The form, fit, and function of the equipment is identical.
(5) Exterior appearance photographs
An image of the new label is shown below. The FCC ID label goes on the inside surface of the bulkhead at the
top of the rack. External photographs of the unit are shown on the following page.