Furuno USA Inc 9ZWRTR081A Manuale Utente

Pagina di 155
1. MOUNTING 
 
1-16
1.3 Control 
Unit 
The control unit may be mounted on a tabletop, with or without the KB fixing metal 
(supplied), which mounts the control unit at an angle. 
 
Mounting considerations 
When selecting a mounting location, keep in mind the following points: 
•  Select a location where the control unit can be operated conveniently. 
•  Locate the unit away from heat sources because of heat that can build up inside the 
cabinet. 
•  Locate the equipment away from places subject to water splash and rain. 
•  Determine the mounting location considering the length of the signal cable between the 
control unit and the processor unit. (The signal cable comes in lengths of 10 m). 
•  A magnetic compass will be affected if the control unit is placed too close to the magnetic 
compass. Observe the compass safe distances on page ii to prevent deviation of a 
magnetic compass. 
 
Fixing without KB fixing plate 
1.  Fix the KB fixing plate to the rear panel of the control unit. 
2.  Attach cushions (three for RCU-014, two for RCU-015/016) to the bottom of the control 
unit as shown below. 
3.  Fix it to a desired location with tapping screws. 
 
Cushion
KB fixing plate
 
RCU-014/015/016, side view