SANYO Electric Co. Ltd. SCP-62H Manuale Utente
9
Turning your Phone ON and OFF
Turning your Phone ON:
To turn your phone on, press END/.
Once your phone is ON, it displays “Looking for service...” indicating that your phone is
searching for a signal. When your phone finds a signal, it automatically enters Standby
mode – the phone’s idle state. At this point, you are ready to begin making and receiving
calls. If your phone is unable to find a signal after 15 minutes of searching, a Power
Save feature is automatically activated. When a signal is found, your phone
automatically returns to Standby mode. In power save mode, your phone searches for a
signal periodically without your intervention. You can also initiate a search for Sprint
PCS service by pressing any key (when your phone is turned ON).
To turn your phone on, press END/.
Once your phone is ON, it displays “Looking for service...” indicating that your phone is
searching for a signal. When your phone finds a signal, it automatically enters Standby
mode – the phone’s idle state. At this point, you are ready to begin making and receiving
calls. If your phone is unable to find a signal after 15 minutes of searching, a Power
Save feature is automatically activated. When a signal is found, your phone
automatically returns to Standby mode. In power save mode, your phone searches for a
signal periodically without your intervention. You can also initiate a search for Sprint
PCS service by pressing any key (when your phone is turned ON).
Tip:
The Power Save feature helps to conserve your battery power when you are in an area where there
is no signal.
Turning the Phone Off:
Press END/ for approximately two seconds until you see “Powering off” on the display.
Your screen remains blank while your phone is off.
Press END/ for approximately two seconds until you see “Powering off” on the display.
Your screen remains blank while your phone is off.
Unlocking the Phone
1. Press END/ to turn the phone on.
2. When “Locked” is shown on the display, press Unlock(left softkey).
3. Enter your four-digit lock code. For security purposes, the code is not visible as you
2. When “Locked” is shown on the display, press Unlock(left softkey).
3. Enter your four-digit lock code. For security purposes, the code is not visible as you
type.
Using the Battery
Installing the Battery
Your Sprint PCS Phone comes with a Lithium Ion battery. Follow these steps to install
it:
1. Place the battery into the space beneath the antenna with the metal contacts at the
Your Sprint PCS Phone comes with a Lithium Ion battery. Follow these steps to install
it:
1. Place the battery into the space beneath the antenna with the metal contacts at the
bottom, facing downward.
2. Gently press down until it’s in place and the battery release latch snaps.
Removing the Battery
To remove your battery for charging or for another reason, follow these easy steps:
1. Make sure the power is off so that you don’t lose any stored numbers or messages.
2. Press up the battery release latch and hold the battery, then pull it up and out at a
To remove your battery for charging or for another reason, follow these easy steps:
1. Make sure the power is off so that you don’t lose any stored numbers or messages.
2. Press up the battery release latch and hold the battery, then pull it up and out at a
45-degree angle.