ICOM 268201 Manuale Utente

26

4

BIIS OPERATION

25

4

BIIS OPERATION

D

D Direct code entry

q During standby condition, push [TX Code Enter] to enter the TX

code edit mode.

• Editable digit code blinks.

w Push [TX Code Enter] to select the desired digit to be edited.

• Editable digit number is differ according to the setting.

e Set the desired digit using [

]/[

]/[TX Code CH Up]/[TX

Code CH Down].

r Push [TX Code Enter] to set the digit and the editable digit move

to right automatically.

t Repeat e and r to input all allowed digits.
y Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and 

“

”

is

displayed during each call. However, an error beep sounds
and 

“

”

is displayed when no answer back is received

after the calls.

u Push [PTT] to transmit; release to receive.
i Push [P3] (Moni(Audi)) to send the “Clear down” signal.

For your information
When the “UpDate” setting for the call code is enabled, the set code
is overwritten into the call code memory.

■ Receiving a message

D

D Receiving a status message

q When a status message is received;

• Beeps sound.
• The calling station ID (or text) and the status message is displayed

alternately, depending on the setting.

w Push [P3] (Moni(Audi)) to return to standby condition.

NOTE: Only the calling station ID (or text) is displayed (no
message is displayed alternately) when the scroll timer is set
to “OFF”. In this case, push [Status Up]/[Status Down] to dis-
play the status message manually.

!IC-F50_F60 BIIS.qxd  03.9.3 1:38 PM  Page 25 (1,1)