ICOM 269800 Manuale Utente

■ Offset frequency

When communicating thorough a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.

q Push [SET

] to enter set mode.

w Push [SET] or [MONI] until “±” and offset frequency ap-

pear.

e Rotate [DIAL] to set the desired offset frequency.

• Push [V/MHz] to select the 1 MHz tuning steps.

r Push [TONE

] to exit set mode.

z Push [

B(D-OFF)] to enter set mode.

x Push [

B(D-OFF)] or [

C(T-OFF)] until “±”

and offset frequency appear.

c Push [Y

Y] or [Z

Z] to set the desired offset.

• Direct frequency entry from the keypad is not possi-

ble.

v Push [

A(MW)] to exit set mode.

■ Repeater lockout

This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.

q Push [PWR] to turn power OFF.
w While pushing [SET

], turn power ON to enter ini-

tial set mode.

e Push [SET] or [MONI] several times until the “RLO” dis-

play appears as shown below.

r Rotate [DIAL] to turn the repeater lockout function to “RP,”

“BU” or OFF.

• “RP”: Transmit is inhibited when a signal with un-matched sub-

audible tone is received.

• “BU”: Transmit is inhibited when a signal is received.

t Push [PWR] to exit initial set mode.

[PWR]

[SET 

LOCK

 ]

Push

SET

B

21

4

REPEATER OPERATION