ICOM 270600 Manuale Utente

v

New2001

PRECAUTION

RWARNING! NEVER 

connect the transceiver to an AC

outlet. This may pose a fire hazard or result in an electric
shock.

Changes or modifications to this device, not ex-

pressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.

connect the transceiver to a power source of more

than 16 V DC or use reverse polarity. This will ruin the trans-
ceiver.

cut the DC power cable between the DC plug and

fuse holder. If an incorrect connection is made after cutting,
the transceiver may be damaged.

place the transceiver where normal operation of the

vessel may be hindered or where it could cause bodily injury.

the transceiver at least 3.3 ft (1 m) away from the

ship’s navigation compass.

use or place the transceiver in areas with temper-

atures below –4°F (–20°C) or above +140°F (+60°C) or, in
areas subject to direct sunlight, such as the dashboard.

the use of chemical agents such as benzine or al-

cohol when cleaning, as they may damage the transceiver
surfaces.

The transceiver rear panel will become

hot when operating continuously for long periods.
Place the transceiver in a secure place to avoid inadvertent
use by children.

The transceiver and optional HM-127*em-

ploy waterproof construction, which corresponds to JIS wa-
terproof specification, Grade 7 (1 m/30 min.). However, once
the transceiver or microphone has been dropped, water-
proofing cannot be guaranteed due to the fact that the case
may be cracked, or the waterproof seal damaged, etc.
*IC-M402A only

!IC-M402A_SA_draft.qxd  03.10.20 11:41 AM  Page v (1,1)