ICOM 282600 Manuale Utente
31
8
SCAN OPERATION
8
D
Memory scan watch
While operating on a VFO frequency or the call channel, mem-
ory scan watch monitors for signals in each memory channel
in sequence, every 5 sec.
ory scan watch monitors for signals in each memory channel
in sequence, every 5 sec.
q Push
[C•
MR
]
to select memory mode, if necessary.
• “X” appears.
w Push
[A•
FUNC
]
, then push
[5•
SCAN
]
to start the memory
scan.
e Push
[A•
FUNC
]
, then push
[7•
PRIO
]
to start the watching.
• VFO is displayed, then the decimal point “
.
”, on the frequency
readout blinks.
• When the signal is detected on the priority channel, the watching
is paused according to the setting of the scan resume condition.
r Push
[D•
CLR
]
to stop the watching.
■
Scan resume condition
When a signal is received during scanning, the scan resume
condition determines what action the transceiver takes. The
transceiver has 2 scan resume conditions available as
illustrated below. Use
condition determines what action the transceiver takes. The
transceiver has 2 scan resume conditions available as
illustrated below. Use
SET MODE
to select the one which best
suits your needs.
q Push
[A•
FUNC
]
, then push
[8•
SET
]
to enter
SET MODE
.
w Push
[
Y
Y
]
or
[
Z
Z
]
several times until “SCP” or “SCt” ap-
pears.
e Rotate
[VOL]
to select the desired scan resume condition.
• Pause scan:
When receiving a signal, scan pauses on
the signal until it disappears. Resumes 2
sec. after the signal disappears.
the signal until it disappears. Resumes 2
sec. after the signal disappears.
• Timer scan:
When receiving a signal, scan pauses on
the signal for 5 sec., 10 sec. or 15 sec.,
then resumes.
the signal for 5 sec., 10 sec. or 15 sec.,
then resumes.
r Push
[
✱
•
ENT
]
(or
[D•
CLR
]
)to set and exit
SET MODE
.
Timer scan
Pause scan
USING
SET MODE