ICOM 289402 Manuale Utente

■

Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
((

☞

p. 20))

q

Rotate [VOL] to turn the power ON.

w

If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.

• 10-keypad can be used for password input depending on ver-

sion:

• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.

Therefore “01234” and “56789” are the same.

e

When the “PASSWORD” indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.

■

Several types of channel selections are available. Methods
may differ according to your system set up.

NON-ZONE TYPE:
Push [CH Up] or [CH Down], or rotate [ROTARY SELEC-
TOR]* to select the desired operating channel, in sequence;
or, push one of [MR-CH 1] to [MR-CH 4] keys to select a
channel directly.

• Up to 16 pre-programmed channels can be selected via [ROTARY

SELECTOR].*

ZONE TYPE:
Push [Zone], then push [CH Up] or [CH Down] or rotate
[ROTARY SELECTOR]* to select the desired zone.

AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.

*Depending on the pre-setting.

0

5

4

9

3

8

2

7

1

6

10

3