ICOM 297400 Manuale Utente

5

2

  0

1

  0

2

■

IC-A210 has two ways to select a desired frequency.

ï 

Select a desired frequency which is used for the next operat-
ing frequency in the standby frequency indicator. Then ex-
change the active frequency for the standby frequency.
NOTE: Operate from “Standby frequency selection(Step 
1-2)” to “Frequency exchanging (Step 2-2)” as pages 5, 6.

ï  

A desired frequency direct selection is available.
Refer to “Direct frequency selection mode operation.”

■

q

  Rotate 

[VOL] clockwise to turn power ON.

 • Previously used frequencies appear in the active and

standby frequency indicators.

w

  Rotate 

[DIAL] and [O-DIAL] to select a desired frequency 

to the standby frequency.

 • The active frequency is not affected.
 • Rotate

[O-DIAL] to set above 1 MHz digit.

 • Rotate

[DIAL] to set below 100 kHz digit.

For quick frequency setting, often used frequen-

cies can be programmed into memory channels. Refer to 
“MEMORY OPERATION” (pages 9–18).
When a memory channel is recalled, the previous standby 
frequency is erased.

 turn the power ON until the air-

craft engines have been started. It is very important for 
protection of the power supply circuit.