ICOM 305600 Manuale Utente
9
2
BASIC OPERATION
1
2
2
n
Turning power ON
q
Push [
] to turn the power ON.
w
If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• 10-keypad* can be used for password input.
*IC-F9511T only:
• The keys as below can be used for password input:
The transceiver detects numbers in the same block as identical.
The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
KEY
NUMBER
0
5
5
4
9
9
3
8
8
2
7
7
1
6
6
P0
P4
P3
P2
P1
P0
P4
P3
P2
P1
*In this instruction manual, these keys are
from the left, called [P0]/[P1]/[P2]/[P3]/[P4].
e
When the “PASSWORD” indication does not clear after
inputting 6 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
Turn the power off and start over in this case.
n
Channel selection
Several types of channel selections are available. Methods
may differ according to your system set up.
may differ according to your system set up.
NON-ZONE TYPE:
Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select the desired operating channel, in sequence; or, push
one of [MR-CH 1] to [MR-CH 4] keys to select a channel di-
rectly.
Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select the desired operating channel, in sequence; or, push
one of [MR-CH 1] to [MR-CH 4] keys to select a channel di-
rectly.
ZONE TYPE:
Push [Zone] then push [CH Up] or [CH Down], or rotate
[Zone Up/Down] to select the desired zone.
Push [Zone] then push [CH Up] or [CH Down], or rotate
[Zone Up/Down] to select the desired zone.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.
Channel setting is not necessary for this type. When turning
power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call.