ICOM 316800 Manuale Utente

Screw position 
when removing battery 

Screw position 
when attaching battery 

Make sure the rubber seal (purple) is properly seated in the 
groove and dust or other material does not adhere to it.

Battery pack

Battery pack

Rubber seal

Groove

When  attaching  a  battery  pack,  make  sure  dust  or  other 
material does not adhere to the rubber seal. If dust or other 
material  is  on  the  seal  when  attaching  a  battery  pack, 
waterproof protection may not be guaranteed.

ï

To remove the battery pack:
Turn the screw counter clockwise one quarter turn, then pull 
the battery pack in the direction of the arrow as shown below.

To attach the battery pack:
Insert the battery pack in the transceiver completely, then 
turn the screw clockwise one quarter turn.

NEVER remove or insert the battery pack when the trans-
ceiver is wet or soiled. This may result water or dust get-
ting into the transceiver/battery pack and may result in the 
transceiver being damaged.

NOTE: When removing or attaching the battery pack, use 
a coin or standard screwdriver to loosen or tighten the 
bottom screw.

CAUTION!:
When attaching or removing a battery pack, make sure 
the rubber seal is set in the groove of the battery pack 
correctly. If the seal is not correctly in the groove, it may 
be damaged when attaching the battery pack. If the seal 
is damaged, waterproof protection is not guaranteed.

3

2

SUPPLIED ACCESSORIES AND ATTACHMENTS