ICOM 318200 Manuale Utente
93
DATA COMMUNICATION
11
N
Before operating packet (AFSK), be sure to consult the
operating manual that came with your TNC.
operating manual that came with your TNC.
q Connect the TNC and PC. (p. 92)
w Select the desired band. (p. 25)
e Push [SSB] or [AM/FM] to select the desired oper-
ating mode.
r Hold down the same key you pushed in step e for
1 second to select the Data mode.
t Rotate [DIAL] to select the desired frequency.
y Transmit your AFSK signals using your PC’s key-
board.
s
s
ted signal is indicated on the Po meter.
s
put power so that the ALC meter reading stays in the
ALC zone.
ALC zone.
./4% When connecting the TNC to the ACC socket
on the rear panel, select the USB, LSB, AM and FM
data mode, or disconnect the microphone and ro-
tate the [MIC] control fully counterclockwise.
on the rear panel, select the USB, LSB, AM and FM
data mode, or disconnect the microphone and ro-
tate the [MIC] control fully counterclockwise.
When the SSB data mode is selected, the audio
input from the [MIC] connector is automatically cut,
and the audio input from the [ACC] socket is used.
input from the [MIC] connector is automatically cut,
and the audio input from the [ACC] socket is used.
Also, when the SSB data mode is selected, the fixed
settings listed below are automatically selected;
settings listed below are automatically selected;
s
(Fixed to the default value;
300 Hz to 2700 Hz.)
s
s
s
Mark freq.: 2125 Hz
Shift freq.: 200 Hz
Shift freq.: 200 Hz
2325 Hz
200 Hz
2125 Hz
Carrier point
(Displayed frequency)
When operating AFSK in the SSB mode, the displayed
frequency is the signal’s carrier point.
frequency is the signal’s carrier point.
D
Appears when the data mode is selected.
[AM/FM]
[DIAL]
[SSB]